We're super excited to share more crafty DIY ideas with you.
You'll need to check your inbox for an email from us to confirm your request went through.
And why not let others know about it too.
Keep your beer safe between sips with these easy to make, nifty little beer holders. All you need is some old tins, spray paint, wood off cuts, washers , 8 mm thread bar and some 8 mm nuts.
The tins we used were a quite deep, which made it a little difficult to grab a beer if it was in a can – it kinda get lost inside the tins. So we cut circles from wood off cuts using a hole saw and then we drilled a 8 mm hole in the center of each wooden circle and in the bottom of the tin cans.
We sprayed the cans and wooden circles using some left over Rust-Oleum textured paint from one of our other projects and began joining up all the bits. Take a 8 mm nut and thread it onto the thread bar, then add a big, fat washer, insert the thread bar into the tin can , add another big fat washer and another nut. Tighten the nuts and squish the wooden circle onto the thread bar on the inside of the can.
Now go grab your favourite beverage, jab your nifty little holder in the grass and your ready to go, safe in the knowledge that your newly opened beer won’t tip over 😎
P.S. For a personal touch add some chalk board labels.
P.S.S Plonk some ice cubes in the tin can before inserting your beer for that perfectly chilled effect